READ WELL BEFORE.
MATERIAL USED FOR THE LION.
This is a list of all known materials which are used almost always:
- Scissors, needle, pins, thread to machine, thimble, fill, coarse linen thread, some thin rope.
This is another list of tools.
- A fine hook, a soft pencil or pen with water, a needle wool, a long thin screwdriver, a black or brown permanent marker.
Fabrics:
- Felt light brown solid in oil patch.
This is another list of tools.
- A fine hook, a soft pencil or pen with water, a needle wool, a long thin screwdriver, a black or brown permanent marker.
Fabrics:
- Felt light brown solid in oil patch.
Note: I have reduced the lion is 100% original.
BEGIN:
1 - draw the contour pattern fabric layer and using the reverse of it.
2 - marked the opening as shown in the photo. For this opening will turn the piece. 
3 - Now we have to make the sandwich. The position and order of the layers of fabric and padding is important.
-first position in the fabric will be placed where we set the pattern. This fabric will LION BACK.
"Secondly there is another fabric. The right sides of the former and the latter shall be faced, if your fabric has the right side and vice versa.
-Third post the batting. The fabric that we have and batting second will be the FRONT of the figure, there is placed the hair and face. We advise you to make a mark to know which part is the back or side is the face.
"Secondly there is another fabric. The right sides of the former and the latter shall be faced, if your fabric has the right side and vice versa.
-Third post the batting. The fabric that we have and batting second will be the FRONT of the figure, there is placed the hair and face. We advise you to make a mark to know which part is the back or side is the face.
The batting has to be fine, we use the 80% cotton, 20% synthetic.
4 - After the contour sewing machine have to do pickets as shown in the photo. 5 - sew the sandwich machine, very slowly and with a small stitch. We begin, as always, at the point where the opening starts, finishing well and we sew all the way around to the point where the opening ends. Finish off again.
6 - Once cut machine sewn to the shape of sewing and 3 mm left margin. After we cut the margin to padding, only the margin and ... 
7 - are given the corresponding picket point you in the picture number 4. 
8 - This part will be ready to flip. 
9 - Now we have to turn the body of a lion. It is not difficult because it has a large opening, but we have used the "tour" so that the seams do not suffer, especially when turning to the legs. 
10 - These two pictures to remind you I have done work as the seams once turned the piece. The rear of the hook is inserted through the opening and used to fully remove the seams and once round and the screwdriver to get a very pronounced peak that we have become the sewing machine. 
11 - Mark the reference point to position and sew the tail y. .. 
12 - it also outlines the contour of the opening to ... 
13 - fold line and baste seams to be stuck and not moving slightly after filling the room. 
14 - Sewing for closing the opening using a hidden stitch. 
15 - are now beginning to face the lion. To have felt a little consistency in what you permeate Hairspray Strong hold. We left him dry a day. pattern is first cut paper as it is in the photo above (14).
16 - After drawing the outline on the felt. Yet, not drawn the hole where the face anger. 
17 - We cut the lion's mane. First we split a side of one end, turn the piece of felt and chop the other side of the tip. This is how we cut to the tips are well marked. 
So we will.
18 - This is the time to make very soft reference Where will lion stitched face. 
and make reference holes and then position the eyes, whiskers, mouth and nose. 
So we will be the benchmarks. 
19 - With a fine tip permanent marker, draw two redondelitos for eyes, a triangle for the nose and a line down to the mouth. (See photo 21) The points we have made to the whiskers are painted with a small dot. If you use the pen apretéis not much ink will run. 
20 - cut out the shape leaving 3 mm margin. 
21 - This step is optional. We usually spend a basting around the rim and a little separated from it, as shown in the photo. Then loosen the string and sewing purses, getting a little inward, so the outline is rounded and we facilitate the implementation of this piece to the felt. 
22 - sew or stitch applique face hidden by matching the contours we have drawn in step 18 with the edge of the face. L 
23 - To join the head to the body use its whiskers. We spent the ends of the thread one by one. Insert the needle behind lion's body and we get the one point that we painted for the whiskers. 
24 - We take the needle thread and the thread in the other end of it (that will be back) the back to move forward and tie the two ends. We repeat the same with the other mustache. 
So you have to get back. 
25 - with a piece of rope knotted 7 cm in length each end. One of them almost flush cut and sew the reference point where we set the tail. 
0 comments:
Post a Comment