READ WELL BEFORE. MATERIAL USED FOR THE HEART.
This is a list of all known materials and are almost always used:
- Scissors, needle, pins, thread to machine, thimble, stuffing, DMC skeins in different colors. This is another list
tools.
- A fine hook, a soft pencil or pen water, needle, wool, wire of 0.60 mm. (Gold would be ideal) a long thin screwdriver, a curling iron to cut wire, a round head curling iron.
Fabrics:
- Felt Red.
- Scissors, needle, pins, thread to machine, thimble, stuffing, DMC skeins in different colors. This is another list
tools.
- A fine hook, a soft pencil or pen water, needle, wool, wire of 0.60 mm. (Gold would be ideal) a long thin screwdriver, a curling iron to cut wire, a round head curling iron.
Fabrics:
- Felt Red.
Note: I made my heart smaller, is 60% of the original pattern.
BEGIN:
1 - With the help of a soft pencil and putting double fabric copy the pattern on the felt. 
2 - Mark well where it begins and ends the opening. I will leave that piece without sewing and there you will give back to the room. 
3 - Before cutting the line marked in pencil, sewing machine part. Start well in finishing off the opening point you have marked, follow the pencil line with the stitching and finish sewing on the other point of opening. Top.
When cornering machine to do better not to cut the piece before you start sewing because the machine is better controlled.
When cornering machine to do better not to cut the piece before you start sewing because the machine is better controlled.
4 - Now you can cut your heart in line stitch, leaving a margin of approximately 3 mm. 
5 - Make a picket with the concave curve of the piece so that by turning the seam do not pull. Turn piece.
6 - With a wool sewing needle holes where shown in the photo. As the drill, these points will be useful for reference when we are embroidering. 
7 - Place the pattern over the heart and turned (the opening of it is at the left) well Focus
staff. Mark the points very soft. If you make a lot following points are noted. If you want you can use a marker of water for this operation.
staff. Mark the points very soft. If you make a lot following points are noted. If you want you can use a marker of water for this operation.
8 - Fill slightly. Start getting very little padding on top, push along with the thin screwdriver and then continue with the rest of the heart. Not populated much later is hard to make the scallop. 
9 - Close the opening by hand with a hidden stitch.
10 - embroider the stars with a golden skein DMC (no. 3852) using two strands of thread.
11 - We altededor festoon the heart with a skein DMC Taupe (no. 3023) using two strands of thread. 
12 - We connect the dots that make up the word "Joy" with a pencil or a marker of water. If you do it in pencil, very soft . 
13 - embroider the word "Joy" with a big stitching and the same web that we used to do the scallop. Use two strands of thread.
14 - winding wire of 0.60 mm. around a pencil. There are two laps.
15 - In the clip, cut at their intersection. Will two-ring opening. 
16 - Cut another piece of wire (0.60 mm.) Of 10 cm. and the curling round head do a double loop at each end. We give a half-circle to the rest of the ring.
17 - We put the rings we did in step 15 by the loops. 
18 - With the needle wool to make two holes centered on top of the heart. See photo.
19 - Enter rings through the holes we just made. Maybe you have them open a bit to fit with ease. If so then resealed with tenecillas round.
0 comments:
Post a Comment