READ WELL BEFORE.
material for use in strawberries.
Note: I have made my strawberry smallest is 60% of the original pattern.
This is a list of all known materials which are used most often: - Scissors, needle, pins, thread to machine, thimble, stuffing, DMC skeins in different colors.
This is another list of tools.
- A fine hook, the twist-fold bias small, a soft pencil, a needle wool, a long thin screwdriver, an awl.
Fabrics:
- Felt Red, green felt and a piece of fabric that combines solid green patch with green felt.
BEGIN:
1 - With the help of a soft pencil and putting double fabric, copy the pattern cutter body in red felt. Place the top single employer felt as shown in the photo.
2 - We cut the line marked in pencil, leaving a small margin (3-4mm). 
3 - You will pass a large stitch stitch (# 4 on my machine) to 3 mm. the top edge. finish off well by starting to sew, when we reach the end did not finish and leave a piece of loose thread. This is then able to pull one of the threads that have become loose and wrinkle.
4 - With the wool needle punch holes in all there are black dots in the pattern. 
5 - Fold in half the pattern (the pencil mark you made in step 1 has to be in). Insert the pen tip while the softness giráis with for all points are marked on the felt. The embroidery marks can also be made with a water pen disappear more easily than the pen. Then turn and make the same points in the other half of the strawberry. These spots are marked embroider more easily and, if you have done well, will be equidistant. 
6 - dots are embroidered all marked in pencil. I used 4 strands of a skein DMC ecru or pale yellow (To taste). The point used is a "French knot." 
7 - We turn back the fabric (the dotted edges are just inside) and close the opening and stitch rather small (2 - 2.5 on my machine) over the line marked pencil. Finish off. 
8 - We turn the piece and fill it (not very, verrry filling). Finally we pulled one of the threads that were left loose in Section 3 for gathering. Pull gently because the thread may break and NOT CLOSE COMPLETELY (see photo). While the thread finish of the of which we have thrown away. If the thread breaks can pucker opening hand, in this case use a stitch very often and, of course, finishing. 
9 - Copy the pattern of strawberry leaves the green felt. Just cut out the pencil line with no margin. 
10 - Cut a piece of cloth, in a green solid, 6 x 2cm.
11 - We had a double-stitching machine and leave one end open so you can enter the tour-fold bias. We turn to the tail with a "tour" small and with the help of a long thin screwdriver and fill it slightly. We put waaaay too little filling and make it more gently because the seams can tear if we force too much fabric.
12 - When the tail is filled and if you do not like as has been the end is in sight, you can use the back of a hook to get him a fine little inward. In is a nice quederá dissimulate the defect.
13 - Position the leaves completely covering the opening of which we have made in advance and join the cutter body with scallop point. The nice thing would be not gathers any significant that we have been doing step # 8. 
14 - With an awl make a hole in the center of the leaves and we put the tail 1.5 cm inward. I have not glued or sewn because it is released. 
Et ...... voilà completed.
0 comments:
Post a Comment