Books Published By The Live Poets Society Of Nj

a dove.




READ WELL BEFORE.

MATERIAL USED IN THE PIGEON.

This is a list of all known materials and are almost always used:

- Scissors, needle, pins, thread machine, thimble, stuffing, lace and red ribbon.
This is another list of tools.
- A white pencil, needle, wool, two black beads.
Fabrics:
- off-white and orange felt.

Note: The dove is 90% of the original.

BEGIN:

Felt so you can use white or even dye it with coffee. The instructions to dye the felt is in the entry "A Rabbit."

1 - With a soft pencil, transfer the pattern pieces to the felt. To do, twice the body, two wings and base. Make reference marks to locate the peak later. The space between these marks not sew. (See photo).

2 - These are the stitches that will be needed once the pieces and stitched before turning.

3 - These are the pieces once cut. We left about 3 mm margin around each piece. You can take advantage and cut the peak (see photo for the shape) of the dove on a piece of toast and orange felt.

4 - The figure that we are doing is one of the easiest of the SAL, the only difficulty is to sew the pieces correctly so that no seams trapped. Now we are going to provide guidelines to continue to sew the pieces to each other without much difficulty. We advise
hilvanéis each piece to be sewn to the seams will not move with the drag of the machine. Very well finish in the points where it starts and ends of sewing and reading all this before getting down to work.

5- Primero coseremos la pieza correspondiente al vientre a una parte del cuerpo. Empezamos en el CENTRO de la curva que forma la cola y terminamos en el CENTRO del pecho. No coser los márgenes, llegar sólo hasta la raya que habéis marcado con lápiz y rematar.

6- Ahora hacemos la segunda costura. Colocamos la otra parte del patrón del cuerpo de la paloma en la posición correcta, hilvanamos para que las costuras no se muevan y cosemos desde el primer punto que hemos hecho para el pico hasta el centro que hace la curva de la cola. (ver foto) se indica con fingers.

7-Now baste the other side and sew from the center of the curve of the tail to the chest. We can also sew the contrary, ie, from breast to tail, that as you easier. Try not to pinch the edges of the seams.

latter stitched seam.

8-To close the piece and finish, sew from the second we did to get the peak of the chest to the point where are the other two seams.

figure we turned the tail have to be like in this photo.

and the share of the chest and in the other photo.

9 - Now comes what we have done many times, putting the pattern onto the piece upside down and do benchmarks. The reference points to are the eyes and small marks to position the wings. The same operation on the other side of the figure.

10 - Make a cut in only part of the body. Shall be put around the filling and flips the figure. Using the rotating bias to turn the figure so that we have made the cut will not increase in size. Later apply a wing covering the pit.

11 - Fill the piece enough to close the opening by a crucetilla.

12 - To fit the peak we used glue. While both sides are impregnated base peak and the opening we left without stitches in his head. Peak is introduced into the opening.

13 - it is pressed and dried.

14 - The eyes are two black beads are sewn on both sides of the face, wings apply benchmarks covering made previously hidden by stitch.