How To Put On Front License Plate Bmw

a basket and a chicken.


READ WELL BEFORE.

material for use in CART.

This is a list of all known materials which are used most often:

- Scissors, needle, pins, thread machine, thimble, filling.
This is another list of tools.
- A white pencil, needle, wool, two black beads, two small white buttons, black wire, white glue.
Fabrics:
- Felt in white, gold, orange and red.

Note: The Basket and Chicken are 80% of the original.

BEGIN:


1 - With a soft pencil copy gold felt:
- 2 times the body of the chick.
- 2 wings.
- 1 times the base or belly.

In reference patterns must be by a few points, the situation will peak. The space between the points are sewn.

This point is in the chest of the figure is important. Mark, because that is the reference to start sewing the part corresponding to the belly or base.

2 - With a small piece of orange felt or boiler chick beak trimmed. In the picture you can see the size and shape we have given.

3 - These are the pieces cut. As always leave a margin of 3 mm. around each piece.

4 - started sewing, basting before moving to avoid seams. Sew from the dot of reference we have marked chicken breast until the part where it ends. Sewing machine. Not reach the final, sewing is just how far the pencil line. Finish to start sewing and finishing.

This is the stitched seam, always with a small stitch. As we can see only up to the pencil line and finish off.

5 - Now baste the second part of the body that we cut. It interweaves and machine-sewn all around its contour. Start sewing at the first point that you marked for the peak and end of sewing on the second point that has been marked for introducing the same. Top.

6 - We two stitches in the back concave shape of the figure.

7 - Now you have to crank up the pattern of the body that you've sent, the master of the wing and draw a pencil outline of it. Draw the outline of the wing where you girls seem to make it nice and centered. After this operation
wool needle and do the two reference holes you see in the picture.
Finally, the piece without turning, passing references to both sides of the figure. Trace a bit with the pencil so that the points could also be affected by the right to flip the piece.

8 - We make a straight cut without reaching the benchmarks and only part of the figure. We looked the part with the "tour" so that the opening is not deformed or becomes larger.

9 - After turning the figure we get it all seams with the help of the back of a hook and fill it.

10 - closed the court to have done with a crucetilla.

11 - White-tailed impregnate the base of the bill and we left without opening sewing head of the chick.

12 - We put the peak in the opening .....

... and press. Let dry.

13 - The eyes are two beads that is sewn on both sides of the face.

14 - The wings are applied to both sides of the body of the figure. A wing will plug the opening that we used to fill and turn the doll.

So the chicken will be done.

CART.


1 - white or colored felt, cut a body and a basis for making the basket.

2 - Close the body of the basket, setting up some seams and joining with a straight stitch and a small stitch.

3-Then we cut the poinsettia in red felt.

4 - sew the body of the basket and look good with one or two white buttons.

5 - Now on to the handle. To put focus is to find two middle points in the body of the basket. These points are easy if you fold the piece as seen in the photo. Be sure to leave the seam centered in the rear.

6 - After you turn the piece will be a little bit lines marked where the needle is inserted wool to make the holes and thus facilitate the introduction of wire will act as a handle.

7 - preferably a black wire and a length of about 20cm, it is the loop that we have seen in other figures and which shown in the photo.

8 - After having the first threaded end of the handle will be given a semicircular shape the rest of the wire.

9 - Insert the plain end through the first hole we have done in the felt and then the second (see photo).

10 - Now comes the hard part. We have to make another loop in the end we are left with the body of the basket there in the middle and a bit bothering. To see that such.

- Asa completed.

11 - Now comes the easy part. White-tailed permeate the bottom of the basket. We've got a jar of makeup in that pose for the piece above the base and let it dry is not deformed. When dry, remove the bottle.

12 - Gluing the body of the basket at the base.

13 - To put the chicken in the basket and it is high it gets a bit of filler in the basket. The original basket
can see a little miniature tinsel decorating the set but ... we have to wait a little longer and see if I could find.