READ WELL BEFORE.
MATERIAL USED FOR THE SNOWMAN.
This is a list of all known materials and are almost always used:
- Scissors, needle, pins, thread machine, thimble, fill, color skein DMC mole, a coloring paint red.
This is another list of tools.
- A white pencil, wool needle, an awl, two black beads, a small pine pineapple, natural color raffia.
Fabrics:
- felt in black, off white, red and orange.
This is another list of tools.
- A white pencil, wool needle, an awl, two black beads, a small pine pineapple, natural color raffia.
Fabrics:
- felt in black, off white, red and orange.
Note: The Pineapple Snowman is 90% of the original.
BEGIN:
1 - Copy the outline of the pattern on a layer of white felt. 
2 - cut out the shape leaving 3 mm margin and give you a machine stitched along the entire boundary of the circle. The stitch will be great (No. 4) and does not finish because the stitching is to frown. 
3 - impregnate the felt piece in water. 
4 - Then place the piece into a round mold. Tighten the felt against the mold and hold with a rubber band or tape. We leave the wick in the mold until it is completely dry. 
5 - When the wick is dry, remove from pan and keep us a bit of form. 
6 - We pulled one of the threads that have left no crinkle top and base of the circle. Fill with batting and then give a few stitches as shown in the photo to finish off the threads that have become loose to gather. 
7 - The hole in the base is not close at all because that anger hit the tail of the pineapple you will see in the picture below. 
8 - pinyon pine cones do not have the form shown in the photo. What we did was to peel the leaves from the top to make it the central trunk and to introduce air through the gap we have left to knit the piece of felt. 
9 - Before hitting the pineapple we do face. Using a marking pen water points will be located where the eyes, stitches in the mouth and nose. 
10 - will also have to cut the nose of a piece orange felt. The size of the nose is at home. 
11 - Here are the eyes sewn beads which are two large black and given stitches to his mouth. We used 4 ply yarn in taupe Mouliné DMC. 
12 - After we take a small cut and horizontal at the height of the nose. (See photo). 
13 - impregnate glue the base of the nose and the cut we made in the previous step. Enter your nose and let dry. 
14 - To end the face apply blush on both cheeks. 
15 - To place the pineapple at the base of the head of the snowman we opted for the hot glue gun. Apply a little silicone in the hole that has been at the base of the figure. 
16 - Enter the pineapple pressing a bit. Let dry. 
17 - The snowman wearing a scarf around his neck. To make it you have to cut a strip of 25 cm long and 1.5 cm wide, in red felt and make 4 cuts at the ends as shown in the photo. 
18 - This figure wears a black felt hat. To do this I refer to the "Snow Man's Face." 
0 comments:
Post a Comment